HDMI over IP Management Software

The HDMI over IP Management Software allows MuxLab's HDMI over IP encoders (500752-TX) to be routed to MuxLab's HDMI over IP decoders (500752-RX) thereby enabling a virtual matrix switch to be set up between multiple HDMI sources and HDMI displays via an Gigabit Ethernet LAN.

Link to products: HDMI Over IP Transmitter with PoE, HDMI Over IP Receiver with PoE

MuxLab's HDMI over IP Software is available for download to customers who have purchased MuxLab's HDMI over IP Extenders (model 500752-tx, 500752-rx).

Proof of purchase via product serial # is required for software download and will be requested in the coming steps.

About the software

Allows any MuxLab Encoder (500752-TX) to be routed to any MuxLab Decoder (500752-RX)
Runs on windows
Controllable from any PC with LAN access via wired or wireless connection
Allows any HDMI encoder to be switched with any HDMI decoder
Supports matrix switch sizes up to 16x200
Supports any Gigabit Ethernet switch with IGMP enabled
Reset individual ports on the switch if required
Save default configuration to the switch in case of power failure
Supports PoE
Flexible and configurable GUI
Multiple network switches supported as long as they are located in the same subnet
Auto discovery of Device ID switches
Setup Wizard for easy device configuration
Detection of display power "On" or "Off"
Detection of valid HDMI signal on the source and the display
*MuxLab recommends using the Cisco SG300-10P 10-Port Gigabit PoE Managed Switch

Installation Instructions

Asset 5

STEP 1: Please fill in the form below and click 'Next steps' to proceed and get an activation key.

Asset 4

STEP 2: Download the software. If needed, copy the downloaded file to the computer that will manage the 500752 units.

Asset 2

STEP 3: On the target computer, open the file and click "setup.exe" to begin installation. Follow the instructions to complete software activation. You will need internet access during installation in order to get an activation key.

Asset 5

STEP 4: Activate Your Software

You will need to enter your software license key provided in the first steps of installation. You will also need to provide a serial # from one 500752 unit.

    Please fill in the form below and click 'Next step' to proceed and get an activation key* (required).

      Please fill in the form below and a MuxLab representative will get back to you within 24 business hours.